A radium release hitch is a load-releasing hitch using 3:1 mechanical advantage which is used in a two-rope technical rescue system. The Radium Release Hitch allows a load to be transferred from one rope to another and is commonly rigged into the belay line prior to the operation of a two-rope technical rescue system.
A radium release hitch is typically tied with 10 meters of 8mm rope and two locking carabiners. A reasonable length for the hitch (distance between the 2 carabiners) is 10 to 15 cm.
Maps, Directions, and Place Reviews
History
The Radium Release Hitch was developed by Rigging for Rescue (with input from Arnor Larson) as a result of the extensive comparative analysis of release devices undertaken during 1997 through 1999. Or may have been developed by Kirk Mauther from Basecamp Innovations.
Usage
- Passing knots
- Untensioning a locked lowering device or locked up prussiks.
Tying
- Tie a figure 8 on a bight at one end of the cord and clip it into the load carabiner on its spine side.
- Clip the standing part of the rope through the anchor carabiner and back down through the load carabiner; bring the rope back up to the anchor carabiner.
- Tie a Münter hitch on its gate side of the anchor carabiner. Ensure that the Münter hitch is in the release position with the in-feed rope toward the gate side of the carabiner
- Secure the Radium Release Hitch using a bight to tie a half hitch on a bight around the entire stem below the Münter hitch, and then back it up with an overhand on a bight knot again around the entire stem.
- Tie a figure 8 on a bight at the other end, and clip it to a secure anchor.
Source of the article : Wikipedia
EmoticonEmoticon